|
| |
Key Benefits
 |
Used dry clinically, but humidity is controllable |
|
|
The body is warmed comparatively evenly |
|
|
Heating air efficiently allows for good ventilation |
|
|
A milder sweat is produced than all-FIR, but still effective, eliciting
more gradual responses |
|
|
A wide temperature range, clinically 110F-160F (otherwise about
130F-185F) |
"A"
Model
with the radiant backrest turned to view
|
The A Model
The A model is a comfortable, personal Finnish sauna. A filler panel
is used to create a raised footrest, as shown below. FIR options include
an RB and extra heaters (XIR): underseat, at the feet, or near the
knees. The A1 uses a 2.1kw, 120V heater (20-amp circuit). If that
circuit is not available, a 15-amp heater is used. The A2 uses a 3kw,
240V heater (20-amp circuit). Adding FIR requires a 2nd circuit (15-amp,
120V). The one exception: one 20-amp, 120V circuit can handle the A1
with an RB and the small 15-amp stone heater. |
M1
The M1 is 4’7” deep by 6’2” wide. The main, rear bench is 5’10” long.
A lower 4’ 2” bench runs front-to-back along the right side wall, under
the rear bench. This yields a temperature variance of about 15°F between
levels, which is often ideal for couples bathing together, so they each
have their own personal comfort zone. |
This
M1 model includes 2 Radiant Backrests
|
M2
The M2 model is the same 4’7” deep as the M1, but it is 7’6” wide. It
has an elevated “L” bench of 4’2” x a full 7’. A lower level, with a
step and a seat, parallels the upper seating. This is a comfortable
sauna room for 3 or 4, and it will accommodate a very tall bather who
desires
to recline in the sauna. |
An M2 model with 3 Radiant Backrests
|
M3
The M3 model, our largest, is 5’9” deep by 7’6” wide. This
family-sized sauna allows for a full twin set of high and low L-shaped
benches, including two full 7’ long spans. |
An M3 model with 3 Radiant Backrests
|
The Heaters
Our stone heaters are UL/CSA-approved, deluxe stainless steel models with a
thermostat, timer, and over-heat protection. The hot stones emit FIR abundantly
and allow for humidity control. The air is charged with refreshing negative ions
when the stones are moistened.
RB’s are poplar, semi-mobile “Radiant Backrests” containing recessed
far-infrared heaters. Each has built-in intensity control. They emit FIR energy
mainly in the 4-14 micron range.
At corners, RB’s can be turned against a side wall. You can stretch out and
retain the ideal FIR exposure upon the back, or sit in-between two RBs that are
turned to face each other to create a “sandwiching” effect. By doing this, you
can achieve more far-infrared exposure than is encountered in most other FIR saunas!
|
